Extron-electronics MLC 206 AAP EC User Guide Manuale Utente Scaricare il pdf (Pagina 17)

2-9MediaLink Controllers • Installation

The control modules are Architectural Adapter Plate modules that can be

connected to the MLC to control devices such as VCR, tape, or DVD players,

or provide limited control of an optional MLS 306/506 Series switcher, or

other devices. Up to four control modules (in addition to the IR Link) can be

connected to the MLC, though the connector can hold wires for only 2-3 items

at a time, so you may wish to daisy chain the control modules together.

You must also set the control modules’ rear DIP switches so each control

module has a unique address number.

Wire the MLC’s IR/RCM 3.5 mm, 4-pole direct insertion captive screw

connector as shown in the following illustrations. Refer to the Control Modules

User’s Manual or the Relay Control Modules User’s Manual for information on

setting an address for each device. An Extron Comm-Link cable (see

appendix A for part numbers) is recommended.

MLC

RCM

port

ABCD

RCM

IRCM control

module(s)

ABCDE

Control

module

connector

+12VDC

Control signal (IRCM)

Ground ( )

MLC 206 to a control module

Total distance

from MLC:

150' (45.7 m)

max.

VCR CONTROL

REW PLAY FWD PAUSE STOP

MLC 206

Extron

MediaLink Controller

MLC 206

DISPLAY

POWER

VOLUME

MAX/

MIN

VCR DVD Laptop

MLC

IRCM

port

ABCD

RCM

ABCDE

IR Link

connector

Modulated IR (IR Link)

+12VDC

Ground ( )

MLC 206 to an IR Link

Total distance

from MLC:

150' (45.7 m) max.

IR Link

IR signal

repeater

MLA-Remote

SIGNAL

IR LINK

MLC 206

Extron

MediaLink Controller

MLC 206

DISPLAY

POWER

VOLUME

MAX/

MIN

VCR DVD Laptop

CAUTION

Polarity is important. If the IR/RCM connector wiring specified in the

diagram is not followed, the equipment may be damaged.

Connect a maximum of one (1) IR Link. Do not connect more than one

IR Link (either in parallel or in series). Also, do not connect more than four

(4) control modules to the MLC.

The MLC contains three relays, so you may install a maximum of one

RCM-SC or one RCM-SCLT in a system with an MLC.

The control modules are not hot swappable. When you add or remove a control

module, you must cycle (disconnect, then reconnect) the MLC’s power before

the MLC can recognize the new module and the configuration change.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 71 72

Commenti su questo manuale

Nessun commento

Extron-electronics MLC 206 AAP EC User Guide Manuale Utente Pagina 17

Commenti su questo manuale

Prodotti e manuali riguardandi Hardware Extron-electronics MLC 206 AAP EC User Guide