Extron-electronics PIP 444 User Guide Manuale Utente Pagina 3

  • Scaricare
  • Aggiungi ai miei manuali
  • Stampa
  • Pagina
    / 62
  • Indice
  • SEGNALIBRI
  • Valutato. / 5. Basato su recensioni clienti
Vedere la pagina 2
QS-1PIP 422 and PIP 444 Picture-in-Picture Processors • Quick Start
Quick Start — PIP 422 and PIP 444
Installation
Step 1
For tabletop placement, install the four rubber
feet on the bottom of the PIP picture-in-picture
processor. Otherwise, mount the processor in a
rack using the included rack ears or install the
processor in furniture.
Step 2
Turn off power to the input and output devices,
and remove the power cords from them.
Step 3
Input connectors — Connect up to two (PIP 422)
or four (PIP 444) component video, S-video, or
composite video input devices to the top (input)
set of rear panel Inputs BNC connectors (3, 4).
Step 4
Loop-through connectors — If desired, connect
up to two (PIP 422) or four (PIP 444) component
video, S-video, or composite video display
devices to the bottom (buffered loop-through) set
of rear panel Inputs BNC connectors (3, 4).
R-Y
Component Video
Input
S-Video
Y/VID B-Y/C
1
I
N
P
U
T
S
R-Y Y/VID B-Y/C
1
Composite Video
I
N
P
U
T
S
R-Y Y/VID B-Y/C
1
I
N
P
U
T
S
Buffered
L
oop-through
Input
Buffered
L
oop-through
Input
Buffered
L
oop-through
3, 4
Step 5
Output connectors — Connect a component
video, S-video, and/or composite video display
device to the rear panel Output BNC connectors (5).
The component video, S-video, and
composite video outputs are all active
simultaneously, so multiple displays can
be connected.
Step 6 (PIP 444 only)
Genlock connectors —
In(put) connector — If
desired, connect an external
black burst signal to the rear
panel Genlock Input BNC
connector for genlocking the
video signal in broadcast or
other sync-critical applications (6).
Out(put) connector — Connect any downstream
equipment that requires genlocking to the rear
panel Genlock Output BNC connector to route
the black burst signal throughout the system in
broadcast or other sync-critical applications.
If no device is connected to the output,
terminate the Genlock output with the
included 75-ohm terminator .
Composite Video
S-Video
Component video
VIDEO
Y
C
R-Y Y B-Y
O
U
T
P
U
T
S
VIDEO
Y
C
R-Y Y B-Y
O
U
T
P
U
T
S
VIDEO
Y
C
R-Y Y B-Y
O
U
T
P
U
T
S
5
6
IN
OUT
G
E
N
L
O
C
K
Vedere la pagina 2
1 2 3 4 5 6 7 8 ... 61 62

Commenti su questo manuale

Nessun commento