Extron-electronics P-2 DA6xi User Guide Manuale Utente Scaricare il pdf (Pagina 10)

P/2 DA4xi/6xi • User’s Guide

P/2 DA4xi and P/2 DA6xi, cont’d

P/2 DA4xi/6xi • User’s Guide

Operation

After the distribution amplier and its connected devices are

powered up, the system is fully operational. If any problems

occur, verify that the cables are properly routed and connected.

Signal input and output connections

All connections, including power, input, and output, are located

on the rear panel of the P/2 DA4xi and P/2 DA6xi.

To make input and output connections to other devices, do the

following:

Turn off the PC and local monitor.

2. Connect the input cable from the P/2 distribution

amplier (DA) to the computer’s VGA-QXGA output.

If you wish to send RGBHV, RGBS, RGBsB, RsGsBs,

component video, S-video, or composite video signals, use

a standard SY breakout cable to make the connection. See

the illustrations below.

S-video

RGsB,

RsGsBs,

Component

Composite

RGBHV

RGBS

3. Connect the computer’s monitor to the Local Monitor

output of the DA.

Connect VGA-compatible monitors or projectors to the

outputs of the DA.

Connect power to the distribution amplier.

6. Turn on the local monitor, other display devices, and the

PC.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Nessun commento

Extron-electronics P-2 DA6xi User Guide Manuale Utente Pagina 10