Extron-electronics MTP Series User Guide Manuale Utente Scaricare il pdf (Pagina 17)

MTP Series • Installation 11

CAUTIONS: • The length of the exposed (stripped) portion of the copper wires is

important. The ideal length is 3/16 inches (5 mm). Longer bare

wires can short together. Shorter bare wires are not as secure in the

direct insertion connectors and could be pulled out.

• The captive screw audio connector can easily be inadvertently

plugged partially into one receptacle and partially into an adjacent

receptacle. This misconnection could damage the audio output

circuits. Ensure that the connector is plugged fully and only into the

desired input or output

NOTES: • When making connections for the MTP from existing audio cables, see

figure 14 to identify the tip, ring, and sleeve wires in various connectors.

• A mono audio connector consists of the tip and sleeve.

• A stereo audio connector consists of the tip, ring, and sleeve.

• The ring, tip, and sleeve wires are also shown on the captive screw audio

connector diagrams (see figure 13 and figure 21).

Tip (+)

Sleeve ( )

RCA Connector (Mono)

Sleeve ( )

Ring (R)

Tip (L)

3.5 mm Stereo Plug Connector

(unbalanced)

Figure 14. Typical Audio Connectors

Audio input RCA connectors (RCA and AAP models) —

Connect an unbalanced

stereo audio source to these L(eft) and R(ight) RCA connectors (see figure 15).

Sleeve (Gnd )

Right Channel

(Red Jacket)

Left Channel

(White Jacket)

Tip (Signal)

Figure 15. RCA Audio Connectors

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Nessun commento

Extron-electronics MTP Series User Guide Manuale Utente Pagina 17