Extron-electronics Extender Plus Series Setup Guide Manuale Utente Scaricare il pdf (Pagina 2)

68‑2320‑50

Rev. A

09 12

Step 4

Attach and wire the cables as shown in the image below. The Extender Plus D has the same

circuit board configuration. See “Rear Panel Features and Cabling” in the Extender Plus

Series User Guide for more details.

NOTE: If the Extender Plus AAP is installed in an Extron HSA 400 Series or 800 Series

surface access product, install the Extender into the faceplate before attaching the

cables.

Step 5

Connect power and turn the equipment on.

Step 6

Test the system and set the gain switch. Ensure that all devices

receive power. Check and adjust cabling and gain as needed.

Step 7

Disconnect power from all the devices.

Step 8

Mount the line driver into the electrical box or the Plus AAP model into the body of the HSA.

For the Extender Plus D, install the Decora

faceplate.

Step 9

Restore power to the devices.

COMPUTER

OUT

EXTENDER Plus D

L R

NORM

MED

HIGH

STORE

1 2

SELECT

POWER

12V

0.2 A MAX

AUDIO OUT

GAIN

EDID

Audio

Unbalanced Output

Left Tip

NO Ground Here

Sleeve (s)

Right Tip

NO Ground Here

Balanced Output

Sleeve (s)

Left Tip

Right Tip

Left Ring

Right Ring

Sleeve (s)

Left Tip

Right Tip

Left Ring

Right Ring

Audio

12 VDC

Power

CAUTION

Do not tin the wires!

For unbalanced audio, connect the sleeve(s)

to the ground contact. DO NOT connect the

sleeve(s) to the negative (-) contacts.

Extron USA Headquarters Extron USA - West Extron USA - East

+800.633.9876 (Inside USA/Canada Only) +1.714.491.1500 +1.919.850.1000

+1.714.491.1517 FAX +1.919.850.1001 FAX

NORM

MED

HIGH

GAIN

Gain Switch

(viewed

from front)

NOTE: Horizontal sync = black

Vertical sync = yellow

1 2

Commenti su questo manuale

Nessun commento

Extron-electronics Extender Plus Series Setup Guide Manuale Utente Pagina 2

Commenti su questo manuale

Prodotti e manuali riguardandi Hardware Extron-electronics Extender Plus Series Setup Guide