Extron electronics CS 120P Guida Utente Scaricare il pdf (Pagina 16)

15. Remove the speaker grille — Carefully remove the grille from the front of the CS 3T.

NOTE: Grille hooks are provided for grille removal, if needed.

16. Attach the speaker wires to the captive screw connector —

ATTENTION:

• Do not tin the wires. Tinned wires are not as secure in the connector and

could be pulled out.

• Ne pas étamer les câbles. Les câbles étamés ne sont pas aussi bien fixés

dans le connecteur et pourraient être retirés.

Number of Wires per Connection Point Maximum Wire Gauge

1 12 AWG

2 16 AWG

4 18 AWG

Attach the speaker wires to the included four-pole captive screw connector using one of

the following methods:

• Wiring a Single Speaker: Connect the wires to the captive screw connector of the

speaker as shown in figure 13. Be sure to tighten the screws.

Wiring a Single Speaker

Speaker 1

–

LOOP

–

LOOP

(Red)

(Black)

Power Amplifier

Figure 13. Wiring a Single Speaker

• Wiring Multiple Speakers in Parallel: Connect the wires to the captive screw

connectors of the speakers, as shown in figure 14. Be sure to tighten the screws.

Wiring Multiple Speakers in Parallel

Speaker 1

Speaker 2

–

LOOP

–

LOOP

–

LOOP

–

LOOP

(Black)

(Red)

(Black)

Power Amplifier

(Black)

(Red)

Figure 14. Wiring Multiple Speakers in Parallel

In the parallel configuration, all of the speakers downstream of the one being tested

continue to function even when it is disconnected. This is especially useful in

installations where the system can never be completely down, such as in a hospital

setting.

CS 3T and CS 120P User Guide • Installation 11

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 36 37

Commenti su questo manuale

Nessun commento

Extron electronics CS 120P Guida Utente Pagina 16

Commenti su questo manuale

Prodotti e manuali riguardandi Contenitori elettrici Extron electronics CS 120P