Extron electronics 5cr Plus Istruzioni per gli Interventi Scaricare il pdf (Pagina 5)

Press and hold all 3 DISPLAY buttons

together for 2 seconds.

Press the ROOM button twice.

The ROOM LED blinks for 8 seconds.

During that time, do one of the following:

Press any desired front panel button to clear & reset only that button's IR configuration.

Press

all 3 DISPLAY

buttons at the same time for 2 seconds to clear and reset

all

System 5 settings.

Normal Mode

CONFIG LED lights

Setup

(Config)

Mode

With an active audio signal present,

press an input's button twice in quick succession

to adjust its audio input. The input's LED blinks.

Press the input's

button once to

save. Repeat for

each audio input.

Turn VOLUME knob up (clockwise)

until CLIP LED is on or blinking fast.

Turn VOLUME knob

down (counter-clockwise)

until the CLIP LED is off or

blinks occasionally as

the level peaks.

Press and hold the ROOM button

while setting video formats.

Press INPUT3 to toggle between

video formats for that input (an LED

lights to indicate the selected format).

Repeat for VID1 and VID2

Release

the ROOM

button

Point the projector's IR remote

control at the System 5's

IR LEARN port and firmly press

the desired button on the remote.

Press the

DISPLAY POWER,

MUTE, or MODE

button & hold it

for 2 seconds.

CONFIG LED lights steadly while

TX & RETRY LEDs flash to indicate

that the signal has been learned.

If the TX LED is off and the

RETRY LED blinks once, press the

POWER, MUTE, or MODE button

and the IR remote's button again.

For POWER button configuration,

if the TX LED is off and both the

CONFIG and RETRY LEDs blink,

the System 5 is ready to

learn the power-off signal.

Press the System 5's POWER

button twice in quick succession,

then aim the remote and press the

IR remote's power button again.

Repeat all steps for each

DISPLAY button to be learned.

CONFIG LED blinks

At any point after entering

the setup mode, you can

Configure

any of the features described here,

in any order,

Wait 20 seconds to time out to Normal mode.

Press and hold

all 3 DISPLAY buttons

together for 2 seconds

to return to Normal Mode.

Wait 20 seconds

for the System 5 to

time out to Normal Mode.

Setting

audio input

attenuation

levels

Initiating

IR learning

Clearing button

configurations

Selecting

video formats

CONFIG

RETRY

ROOM

DISPLAY

POWER MUTE MODE

DISPLAY

POWER MUTE MODE

VID

MAX.

CLIP

MIN.

Y/C

VID

Y/C

VID

Y/C

PC1 PC2 INPUT3

VOLUME

AUDIO

VID1 VID2

VID

Y/C

VID

Y/C

VID

Y/C

ROOM

DISPLAY

POWER MUTE MODE PC1 PC2 INPUT3 VID1 VID2

CONFIG

RETRY

CONFIG

RETRY

CONFIG

RETRY

CONFIG

RETRY

RX LEARN

CONFIG

RETRY

COMPUTERAUDIO

PC1 INPUT IR

PLUS

SYSTEM 5

VID

Y/C

VID

Y/C

VID

Y/C

ROOM

PC1 PC2 INPUT3 VID1 VID2

1 2 3

4 5 6

7 8

Setup (Configuration) Procedure

1 2 3 4 5 6 7 8 9 10 ... 45 46

Commenti su questo manuale

Nessun commento

Extron electronics 5cr Plus Istruzioni per gli Interventi Pagina 5

Commenti su questo manuale

Prodotti e manuali riguardandi Switch di rete Extron electronics 5cr Plus